Some business printers from Epson include a simple reset button that. Consult your owner's manual to find out more about the 'Alt' key on these models, most.
Epson Stylus ® NX400 Series Start Here 9 Press the OK button to charge the ink. Charging takes about 2½ minutes. Caution: Don’t turn off the NX400 Series while it is charging or you’ll waste ink. Unpack If anything is missing, contact Epson as described on the back.
Caution: Do not open the ink cartridge package until you are ready to install the ink. Cartridges are vacuum packed to maintain reliability.
Canada only: For French speakers, remove stickers from the backing sheet and place over corresponding text on the control panel. 1 3 Squeeze the edge guide and slide it left. Tip: If the feeder guard is in the way, flip it forward. 4 Load paper against the right edge and underneath the tab. Note: Don’t load the paper sideways. 5 Slide the edge guide over. Turn on the NX400 Series 1 Connect the power cable.
Note: Do not connect to the computer at this time. 2 Press the On button.
Load paper 1 Open the paper support and pull up the extensions. 2 Open the output tray, pull out the extensions, and raise the stopper. 5 2 8½ 11 4 6 Change your language You can change the language that appears on your LCD display screen from English to French, Spanish, or Portuguese. 1 Press Setup. 2 Press to select Maintenance, and press OK. 3 Press to select Language, and press OK. 4 Press or to select your language, and press OK.
4 Install cartridges Note: Do not load paper yet. 1 Lift up the scanner. 2 Open the cartridge cover.
3 Shake the ink cartridges, then unpack them. 4 Remove only the yellow tape from each cartridge. Caution: Do not remove any other seals or the cartridge may leak. 5 Insert the cartridges in the holder for each color. 6 Press each cartridge down until it clicks.
7 Close the cartridge cover. Press down until it clicks.
8 Lower the scanner. 3 (Included for Canada only).